Withdrawing From T Addresses to Z Addresses

For security reasons, the private keys of your T addresses are not stored in the Secure/Super Node. Only the private keys of Z addresses are in both Arizen and the Secure/Super Node. To send from a T address to Z address, Arizen is using an intermediate T address on the Secure/Super Node. The amount is sent from your Arizen T address (ART) to the Secure/Super node T address (SNT). When this transaction is complete, or the balance of the SNT address is greater than the amount to be sent, then Arizen sends a command to the Secure/Super Node to initiate the transaction from the SNT to the final destination for the ZEN, to the Z address, see Figures 3.6 and 3.7.

NOTE: The fee will be divided by two, for both transactions. Recommended to set fee to 0.0002 ZEN.

WARNING: DO NOT CLOSE Arizen until the 2nd transaction is sent (opid appears below "Withdraw").

Figure 3.6: If you are sending a transaction from T address to Z address, a confirmation dialogue appears. Click on "OK" to confirm your transaction. Immediately a warning appears. See Figure 3.7.

Figure 3.7: If you are sending a transaction from T address to Z address, a warning appears. It informs you that your ZEN are being sent from T address to the intermediate SNT address and then to the Z address. Please do not close the Arizen wallet until the second transaction is finished.

© 2020 Horizen. All rights reserved.

Browser not supported