Use this page for common commands used to upgrade the node tracker software running on Secure, or Super Nodes
- Upgrading the node tracker
- Check tracker status
Description | Command | |||||
---|---|---|---|---|---|---|
Upgrading the node tracker | ||||||
1 | Stop the running nodetracker process |
| ||||
2 | Change directory to where the node tracker was cloned, this will be ~/nodetracker for the official guide |
| ||||
3 | Update git with the new repository URL and retrieve the latest source code |
NOTE: If git returns an error regarding any files run the following command (replacing 'filename' with the file returned in the error message) and repeat the commands above
| ||||
4 | Install the Node Tracker with npm |
| ||||
Optional - Run nodetracker setup to update configuration settings | ||||||
5 | NOTE: The nodetracker only permits a single setting to be changed at a time between reconnects (IP, FQDN, T-Address, Stake Address)
|
| ||||
Start the nodetracker and check it's status | ||||||
6 | Remove the old pm2 process for the nodetracker |
| ||||
7 | Start the nodetracker process with pm2 and save it |
| ||||
8 | Verify the status after restarting by following the logs and checking for valid output, exit by pressing CTRL + c |
|
Insert excerpt | ||||||
---|---|---|---|---|---|---|
|